Kyocera FS FS-1920 Operation Manual page 152

Kyocera page printer operation guide fs-1920
Table of Contents

Advertisement

Print Quality Problems
Printed Results
Faint or blurred printing
Grey background.
Table 4-2 (Continued)
Corrective Action
Check the Ecoprint setting.
When this setting is On, switch it to Off on the Operator
Panel. (See
Ecoprint
Check the operator panel.
If the Toner low message is displayed and the
ATTENTION indicator is flashing, install a new toner
kit. See
Toner Container Replacement
3-2.
Set the print density from the operator panel to a
higher level than the current setting. See
Density
on page 1-95.
Make sure the paper type setting is correct. See
Paper Type
on page
Clean the charger wire.
Open the printer left cover. Pull the cleaning knob (green
colored) slowly in and out a few times. See
3-9
page
Check the operator panel.
If the Toner low TK-50 message is displayed and the
ATTENTION indicator is flashing, install a new toner kit.
See
Toner Container Replacement
Check the print density.
Display the print density menu from the operator panel
and select a lighter density setting. See
page 1-95.
Clean the charger wire.
Open the printer's left cover. Pull the cleaning knob
(green colored) slowly in and out a few times. See
Container Replacement
Check the charger unit installation.
Open the printer left cover and check that the charger
unit is correctly installed and seated as far as it will go.
Cleaning
on page 3-9.
See
4-4
on page 1-54)
2-12
Cleaning
on page 3-2.
Print Density
on page 3-2.
on page
Print
on
on
Toner

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecosys fs-1920Fs-3820nFs-3830n

Table of Contents