Ram Disk Size - Kyocera FS FS-1920 Operation Manual

Operating the Storage Device
3
The default setting is Off. Press the ENTER key. A blinking question
mark (?) appears. Select On using the
ENTER key.
RAM Disk Mode
? On
4
Press the > key to display >RAM Disk Size.
>RAM Disk Size
0023 Mbyte
5
Press the ENTER key again, and change the RAM disk size using the
or key. It is not possible to make a setting that exceeds total
printer memory. The default value for the RAM disk is the total
printer memory minus 9 MB. This parameter may be set anywhere
from 0001 to 1024 depending on the available printer memory.
6
When the desired RAM disk size is displayed, press the ENTER key.
7
Press the MENU key and restart the printer. The setting will be
activated after restart.
1-82
or key, and then press the