Interface
Serial Interface Parameters
Option
This section applies to the printers having the option serial interface
board kit (IB-11) installed.
The baud rate, data bits, stop bits, parity, and protocol for the serial
interface can be set as follows:
1
Press the MENU key.
2
Press the
or
the interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Serial (when a serial interface board kit is installed)
Option (when a network interface card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the
or
Interface
? Serial
5
Press the ENTER key again.
key repeatedly until Interface > appears. One of
key repeatedly until Serial appears.
1-76