Auto Continue - Kyocera FS FS-1920 Operation Manual

Kyocera page printer operation guide fs-1920
Table of Contents

Advertisement

Configuration
Setting the Auto Continue Recovery Time
Follow the procedure given below to change the recovery time for Auto
Continue.
1
Press the MENU key.
2
Press the
or
Others
3
Press the > key.
4
Press the
or
appears.
>Auto Continue >
Mode
On
5
Press the > key and display >>Auto Continue Timer.
6
Press the ENTER key. A blinking cursor (
>>Auto Continue
Timer
7
Press the
or
where the cursor is blinking and set the desired time. The time must
be set between 000 and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without allowing any
time interval. You can use the > and < keys to move the cursor right
and left.
8
Display the desired time and press the ENTER key.
9
Press the MENU key. The message display returns to Ready.
1-106
key repeatedly until Others > appears.
>
key repeatedly until Auto Continue Mode >
000Sec.
key to increase or decrease the value of the figure
) appears.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecosys fs-1920Fs-3820nFs-3830n

Table of Contents