Cleaning The Charger Grid - Kyocera FS FS-1920 Operation Manual

Cleaning

Cleaning the Charger Grid

The charger grid is a part located at the bottom of the charger unit, which
also needs to be cleaned. You should use a grid cleaner attaching it to the
printer and pull out the charger unit as instructed below.
1
Take the grid cleaner from protective bag in the new toner kit, and
remove the cap.
The grid cleaner pad is supplied with water soaked. Perform the
following procedure before the pad dries.
Note
2
Pull out the charger unit approximately 5 cm (2 inches).
Protective Bag
(1)
(2)
3-10
Cap
Grid Cleaner
Charger Unit