Network Card Interface Status Page - Kyocera FS FS-1920 Operation Manual

Kyocera page printer operation guide fs-1920
Table of Contents

Advertisement

Network Card Interface Status Page

Option
To use this function, the network interface card must be installed on the
printer.
You can print out a status page for the network interface. The network
interface card status page shows the firmware version, the network
addresses, and other information under various network protocols about
the network interface card. The default setting is On (print). If the setting
is changed to Off (not print) as follows, however, the network interface
status page will be printed when the printer status page is printed.
Printing out a network interface card status page may not be possible
with some network interface cards. For details, see the manual for the
network interface card.
Note
1
Press the MENU key.
2
Press the
Interface
Parallel
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the
Interface
? Option
5
Press the ENTER key again. A > appears.
Interface
Option
6
Press the > key and then press the
message display indicates >Opt. StatusPage.
>Opt. StatusPage
On
or
key repeatedly until Interface > appears.
>
or
key repeatedly until Option appears.
>
1-19
Printing Test Pages
or
key repeatedly until the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecosys fs-1920Fs-3820nFs-3830n

Table of Contents