Flash/Recall/Terminate - Panasonic KX-NCP500 Feature Manual

6.1.2 Flash/Recall/Terminate

Conditions
•
Certain buttons are equipped with a light to indicate the status of the corresponding line or feature.
6.1.2 Flash/Recall/Terminate
Description
A proprietary telephone (PT) user can use the FLASH/RECALL button (Flash/Recall mode or Terminate mode)
or Terminate button (Terminate mode) to disconnect the current call and originate another call without hanging
up.
Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the line used last.
For example, if a CO line call is disconnected, the extension user will hear a new dial tone from the same CO
line.
Terminate Mode: Disconnects the line and the extension user hears a dial tone via the preferred CO line.
(® 10.1.3 Line Preference—Outgoing)
Conditions
•
FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
–
Flash/Recall mode
–
Terminate mode
–
EFA mode (® 5.1.1 EFA (External Feature Access))
•
Terminate Button
Any flexible button can be customized as the Terminate button.
•
Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same CO line is programmable for each CO line
port.
•
This feature generates a Station Message Detail Recording (SMDR) call record (® 16.1.4 SMDR (Station
Message Detail Recording)), restarts the call timer, inserts a pause, and checks the Toll Restriction (TRS)
level (® 17.1.6 TRS (Toll Restriction)) again.
•
The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of the mode
that the FLASH/RECALL button has been set to, in the following situations:
–
When a call is made using ARS. (® 1.1.3 ARS (Automatic Route Selection))
–
When a CO line call is made with the INTERCOM button.
–
When a CO line call is made with an Incoming Call Distribution (ICD) group button.
PC Programming Manual References
3.30 [1-1] Slot—Port Property - LCO Port—
3.36 [1-1] Slot—Port Property - T1 Port—
6.1 [4-1-1] Wired Extension—Extension Settings—Option 7—
6.5 [4-1-4] Wired Extension—Flexible Button—
6.10 [4-2-1] Portable Station—Extension Settings—Option 7—
6.13 [4-2-3] Portable Station—Flexible Button—
6.18 [4-3] DSS Console—
PT Programming Manual References
[418] LCOT Disconnect Time
116 Feature Manual
Disconnect Time
Disconnect Time
Type
Type
Type
Flash Mode during CO Conversation
Flash Mode during CO Conversation
Document Version 2013-05