Panasonic KX-NCP500 Feature Manual page 38

3.1.3 Caller ID
[Programming Example: System Speed Dialing Table]
Location
(System Speed
Dialing No.)
000
001
® 8.1 [6-1] System Speed Dial—
*1
® [001] System Speed Dialing Number
® 8.1 [6-1] System Speed Dial—
*2
® [002] System Speed Dialing Name
® 8.1 [6-1] System Speed Dial—
*3
5.
Displaying the Caller's Name
In addition to the System Speed Dialing Table, each extension can store names and numbers in Personal
Speed Dialing. Therefore, it is entirely possible for the same telephone number to be stored under a
different name in different locations within the PBX.
When a call containing Caller ID information is received, the PBX will search for the caller's name in the
following order, then show that name on the display and log it via SMDR.
1.
Personal Speed Dialing data of the extension which received the call
2.
System Speed Dialing Table
3.
The Caller ID information received from the telephone company
If a caller's name is not stored in the PBX or sent from the telephone company, it will not be displayed or
logged.
Conditions
[General]
•
Caller ID signaling type can be selected through system programming.
[Caller ID to SLT Port]
•
Hardware Requirement:
KX-NCP500/KX-NCP1000: A DHLC4 card, SLC8 card, or SLC16 card
KX-TDE100/KX-TDE200: An SLC8 card with an EXT-CID card installed, a CSLC16 card, an MCSLC16
card, or an MCSLC24 card
KX-TDE600: An SLC8 card with an EXT-CID card installed, a CSLC16 card, or an ECSLC24 card, or an
EMSLC24 card.
•
When the caller's number is sent to an SLT, a CO Line Access number can be automatically added to the
telephone number through system programming for calling back.
•
When the caller's number exceeds 16 digits, the SLT receives only the first 16 digits, not counting the
preceding CO Line Access number (if it is programmed to be added).
•
If a call is transferred to an SLT, the transferring extension's information will be shown on the SLT. If the
transferring extension goes on-hook before the call is answered, the original caller's information will be
shown.
•
When Caller ID information such as "Private", "Out of Area", or "Long Distance" is received, this information
will be shown instead of the caller's number and name.
•
Even if the caller's name is sent, the name may not be shown depending on the type of SLT.
•
Incoming Call Log information is not shown on the SLT.
•
Caller ID shows whether the call is an intercom or CO line call by default. This setting can be disabled
through system programming.
38 Feature Manual
System Speed
Telephone No.
Dialing Name
*1
ABC Company 912125551234
XYZ Company 913135551234
CO Line Access Number + Telephone Number
Name
CLI Destination
CLI Destination
*2 *3
200
300
Document Version 2013-05