Canon CP660 Service Manual page 265

No.
9 After making the selection, press the Enter
key.
The message 'LOCALE STORED' will appear
and remain for about 1 sec, to be replaced by
the message 'CHANGE DEFAULT LOCALE:'.
10 Turn off the printer unit, and remove the
PS/PCL Board from the printer unit.
11 Detach the jumper head J27 of the PS/PCL
Board, and install the PS/PCL Board to the
printer unit once again.
12 Turn on the printer unit.
Making Sure of the Change
• You can start the printer unit and print a start page. (Check the name of the prod-
uct, which differs according to the site of installation.)
• While the machine is in ready state, remove the photosensitive drum unit, and close
the front door. If 'INSTALL DRUM CARTRIDGE' appears on the control panel of the
printer unit, the machine is set for user maintenance; if 'SERVICE CALL E810'
appears, it is set for service maintenance.
:
Caution
• If the jumper head is not fitted to J27, the menu for 'CHANGE DEFAULT LOCALE:'
will not appear during the above procedure.
• Do not change any items except 'CHANGE DEFAULT LOCALE:'.
COPYRIGHT © 1999 CANON INC.
Download free service manual at http://printer1.blogspot.com
Work
CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 8 INSTALLATION
Remarks
Be sure to detach the jumper head
from J27, and store away the head for
future use.
8-15