Canon CP660 Service Manual page 157

10. Removing the Sub Transformer 1
1) Perform steps 2) through 5) on p. 4-43
to remove the rear cover and the
shielding box.
2) Perform step 3) on p. 4-55 to remove
the DC controller PCB.
3) Remove the two screws, and discon-
nect the two connectors; then, detach
the sub transformer 1.
w
e
q Screws
e Sub transformer 1
Figure 4-856
11. Removing the Sub Transformer 2
2) Perform steps 2) through 5) on p. 4-43
to remove the rear cover and the
shielding box.
2) Remove the screw, and disconnect
the three connectors; then, detach the
sub transformer 2.
COPYRIGHT © 1999 CANON INC.
Download free service manual at http://printer1.blogspot.com
q
w Connector
CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
w
q Screws
e Sub transformer 2
Figure 4-857
12. Removing the Sub Transformer 3
1) Perform the steps on p. 4-57 to
remove the separation static eliminat-
ing bias PCB.
2) Remove the two screws, and detach
the duct cover.
q
q Screws
Figure 4-858
q
e
w Connectors
w
w Duct cover
4-59