Canon CP660 Service Manual page 145

3. Removing the
Charging Assembly
Intermedate Transfer Drum
1) Remove the two screws, and detach
the secondary pre-transfer charging
assembly from the intermediate trans-
fer drum.
q
q Screws
w Secondary pre-transfer charging
assembly
Figure 4-827
Note:
1. Be sure to place the intermediate
transfer drum on a level surface.
Use paper under the drum.
2. Do not clean the intermediate trans-
fer drum. If absolutely necessary,
wipe its surface with a flannel cloth
moistened with water, and then dry
wipe it.
COPYRIGHT © 1999 CANON INC.
Download free service manual at http://printer1.blogspot.com
Pre-Transfer
from the
w
CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
4. Color Cartridge and Print Image
Faults
Normally, the color toner cartridges (Y,
M, C) may be taken out and put back in
easily. If any of them cannot be moved at
all because of a power fault or the like,
perform the following:
1) Open the front cover.
2) Perform the steps on p. 3-15 to
remove the side cover.
3) Disengage the four claws, and remove
the stopper arm cover.
w
q
q Claws
w Stopper arm cover
Figure 4-828
q
4-47