Symbologies - Wasp Bar Code Laser Scanner Programming Manual

Symbology selection (bar code type) determines which symbologies the
scanner will decode. The chart below shows the symbologies that are
supported by each interface. Once you have identified the symbologies
you wish to enable, turn to the following pages, enable those symbologies
and set the data format options (e.g. check digit, start/stop characters)
required by your host system for each symbology type. You must enable
the symbology format options settings that are compatible with your host
system.
The factory settings for each interface were chosen to meet the standard
industry requirements and in most cases you will not need to change the
symbology format settings. If you are unsure of your system require-
ments, test the scanner using the factory settings before making any
changes.
INTERFACE TYPE
IBM Port 5B
IBM Port 9B
IBM Port E
NCR OCIA (8 bit)
NCR OCIA (9 bit)
OCIA
SNI OCIA
Wand Emulation
RS-232
Keyboard Wedge
KEY
Supported
The symbology can be enabled through configuration items, however,
labels shall not be decoded or transmitted by the interface.
46
S
YMBOLOGIES
SYMBOLOGIES SUPPORTED
Wasp Laser Scanner Programming Guide