Changing Interfaces - Wasp Bar Code Laser Scanner Programming Manual

C I
HANGING NTERFACES
To change a scanner's interface...
If necessary, replace the scanner's interface cable to match the new host
terminal's connection requirements. To disconnect the cable from the
scanner, insert a .050" hex driver or bent paper clip into the CABLE RELEASE
hole, and press down to unlock the cable connector. Reference Figure 1.
We recommend that you disconnect power
before plugging/unplugging cables to avoid any
possibility of equipment damage.
Figure 1. Disconnecting the Interface Cable
1. Verify that your scanner supports the desired interface
below indicates interfaces available at the time of this writing.
Your scanner comes equipped from the factory with the ability to
connect and communicate with at least two major interface types,
for example, Keyboard Wedge/Wand Emulation and OCIA/RS-232
are two common pairings. Contact Informatics if you don't know
your scanner's interface group, or need to have the scanner
altered to change to another I/F group.
1 Contact Informatics if your desired interface is not listed. Interface group definitions
are subject to change without notice.
2
HARDWARE
NOTE
Paper Clip
Interface
Connector
SOFTWARE
Wasp Laser Scanner Programming Guide
1
. The list