Ibm 4682/92 Port E Interface Selection - Wasp Bar Code Laser Scanner Programming Manual

IBM 4682/92 P
Scan this label to enable the IBM 468x/9x Port E interface.
Data Format: Send As Code 39 — converts bar codes data (UPC/EAN,
add-ons, Code 93, Codabar, MSI/Plessey and Code 128) into Code 39
format before sending the data to the host.
These settings are for IBM 4682/92 Port E interface ONLY.
Limit Command Set — is an option that causes the scanner to ignore
'enable scanner' and 'disable scanner' commands sent from the host.
Transmit Unsolicited Status
to transmit a status message to the host upon receipt of an "SNRM".
SET -------------------------------------
S
END AS
D '
ON T
E
NABLE
D
ISABLE
T
RANSMIT
D ' T
ON T RANSMIT
END -------------------------------------
1 For this IBM interface, the setting for Unsolicited Status is normally Disabled.
E I
ORT NTERFACE
IBM 4682/92 P
1
— when enabled, this option causes the scanner
C 39 ------------
ODE
S C 39 ------
END AS ODE
L C S
IMIT OMMAND ET
L C S
IMIT OMMAND
U S
NSOLICITED TATUS
U S
NSOLICITED TATUS
S
ELECTION
E S
ORT ETTINGS
---
--
ET
-
11