Software Control - Wasp Bar Code Laser Scanner Programming Manual

S C
OFTWARE ONTROL
X /X — this is software handshaking that allows the host to
ON OFF
control data transmission. If the host sends an X
the scanner, the scanner will not send the bar code data until it
receives an X
X command during data transmission, the host will receive
OFF
additional characters for no more than 2msec
Hardware/software controls are mutually ex-
clusive. Enable only one of these features at
a time, as enabling multiple controls can pro-
duce unpredictable results.
SET -------------------------------------
D
ISABLE
E CTS/RTS F
NABLE
E
NABLE
E
NABLE
D
ISABLE
END -------------------------------------
1 Varies slightly depending upon baud rate selected.
20
command from the host. If the host sends the
ON
H C
ARDWARE ONTROL
C
LOW ONTROL
CTS S C
CAN ONTROL
X / X ------------
ON OFF
X /X ------------
ON OFF
Wasp Laser Scanner Programming Guide
1
.
NOTE
--
-
--
command to
OFF