Keyboard Wedge; Pc Keyboard Wedge Interface Selection - Wasp Bar Code Laser Scanner Programming Manual

This section contains the following PC Keyboard Wedge communication
parameters in the order listed:
K
EYBOARD
• Interface Selection
• Connect to Laptop
• Caps lock Settings
• Country modes
• Intercharacter Delay
Go to the sections titled Symbology Selection and General Features in the
back of this programming guide if you want to change any other settings.
If the transmission parameters are config-
ured such that a label results in no actual
data to send, the label will be accepted, beeped,
and no data transmitted.
PC K W
EYBOARD
The scanner supports ten PC Keyboard Wedge interfaces. The table below
defines the different interface selections.
I/F Type
A PC/XT w/foreign keyboard
B AT, PS/2 25-286, 30-286, 50, 50Z, 60, 70, 80, 90 & 95 w/foreign keyboard
C PS/2 25 and 30 w/foreign keyboard
D PC/XT w/US keyboard
E AT, PS/2 25-286, 30-286, 50, 50Z, 60, 70, 80, 90 & 95 w/US keyboard
F PS/2 25 and 30 w/US keyboard
G IBM 3xxx w/122 keyboard
H IBM 3xxx w/102 keyboard
I PS/55 5530T w/104 keyboard
J NEC 9801
We recommend that you disconnect power
before plugging/unplugging cables to avoid any
possibility of equipment damage.
24
W C
EDGE OMMUNICATION
NOTE
I S
EDGE NTERFACE
PCs Supported
NOTE
Wasp Laser Scanner Programming Guide
P
ARAMETERS
ELECTION