Low Power Mode - Wasp Bar Code Laser Scanner Programming Manual

L P M
OW OWER ODE
Wasp Laser incorporates two optional low power modes to optimize
power usage and extend scanner life.
These features are only available with
RS-232, Wand Emulation and Keyboard Wedge
host interfaces.
DO NOT use Very Low Power Mode in conjunction
with Stand Mode, as this feature is not compatible
and may cause unexpected behavior.
Low Power Idle—places the scanner's microcontroller into a WAIT
state during idle periods. Any interrupt will bring the scanner to
life, including internal timer and watchdog events.
Very Low Power Mode—(RS-232 and Wand Emulation interfaces
ONLY 1 ) places the scanner in a STOP state during idle periods.
The scanner can only be brought out of its STOP state by a trigger
pull or hardware reset.
SET -------------------------------------
D
ISABLE
L P
OW
V
ERY
END -------------------------------------
1 Very Low Power Mode can be used with RS-232 and Wand Emulation Interfaces
ONLY . If Very Low Power Mode is selected with other interfaces will cause the
scanner to default to Low Power Idle instead.
WARNING
-----------------------
I --------------
OWER DLE
L P M 1
OW OWER ODE
NOTE
----------
85