Wasp Bar Code Laser Scanner Programming Manual page 66

C 39 (
ODE
CONTINUED
Follow these steps to set Code 39 Minimum Label Length:
1. Identify the minimum length setting you want to make. The
selectable range is 00 to 48 characters (Note: For the IBM
Interface, the selectable range is 00 to 32 characters).
2. Scan the SET label.
3. Scan the SET CODE 39 MINIMUM LABEL LENGTH barcode.
S L
ETTING ENGTHS
If you are setting a length less than ten, you must scan a zero first and
then the length digit ( 04, 06, 08).
4. Set the minimum label length by scanning the correct digits
from below and the next page.
5. Scan the END label.
SET -------------------------------------
S M
ET
0 -----------------------------
1 -----------------------------
2 -----------------------------
3 -----------------------------
4 -----------------------------
60
)
L L
INIMUM ABEL ENGTH
Wasp Laser Scanner Programming Guide
---