Debug Mode; Autosense ® Stand Mode - Wasp Bar Code Laser Scanner Programming Manual

D M
EBUG ODE
When enabled, this mode will cause any product labels that are read to be
discarded with no attempt made to transmit them to a host. Any host
scanning control will also be disabled while this option is in effect. This
mode may be enabled in conjunction with any of the defined host inter-
faces. All other programmable options that are set for that interface will
remain in effect while in debug mode.
SET -------------------------------------
E
NABLE
D
ISABLE
END -------------------------------------
®
A S S
UTO ENSE TAND
AutoSense Stand Mode must be enabled when the scanner is used with
the Wasp Laser stand accessory. This feature allows "hands free"
operation of the scanner when placed in the stand.
Very Low Power Mode must be disabled when
using AutoSense Stand Mode, as these fea-
tures are not compatible and may cause unex-
pected behavior.
SET -------------------------------------
E
NABLE
D
ISABLE
END -------------------------------------
86
------------------------
-----------------------
M
ODE
WARNING
------------------------
-----------------------
Wasp Laser Scanner Programming Guide