Table of Contents
Advertisement
2.6.4 Serial ATA Connectors
The system board is equipped with two Serial ATA connectors for
connecting Serial ATA devices. Connect one end of the Serial ATA
cable to J15 (SATA 2) or J16 (SATA 1) and the other end to your
serial ATA device.
BIOS Setting
Enable or disable the onboard SATA in the Integrated Peripherals
submenu ("VIA OnChip IDE Device" section) of the BIOS. Refer to
chapter 3 for more information.
Configuring RAID on SATA Drives
The system board allows configuring RAID on SATA drives. It sup-
ports RAID 0, RAID 1 and JBOD. The following must be set ac-
cordingly.
•
BIOS Setting
Configure RAID (e.g. creating or deleting RAID) in the VIA RAID
BIOS. You can enter this utility by pressing the <Tab> key during
system boot up. Refer to chapter 3 for more information.
•
Drivers and Utility
Install the VIA SATA RAID Drivers and Utility. Refer to chapter 4
for more information.
Hardware Installation
SATA 2
1
SATA 1
2
7
41
Advertisement
Table of Contents
