Table of Contents
Advertisement
2
Hardware Installation
Driver Installation
You may need to install the proper drivers in your operating system
to use the USB device. Refer to your operating system's manual or
documentation for more information.
If you are using a USB 2.0 device, install the "VIA USB 2.0 Drivers".
Refer to chapter 4 for more information.
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a
USB keyboard or USB mouse to wake up the system.
•
Jumper Setting:
JP1 must be set to "2-3 On: 5VSB". Refer to "5V/5VSB Power
Select" in this chapter for more information.
•
BIOS Setting:
Configure the USB device wake up function in the Power Man-
agement Setup submenu ("IRQ/Event Activity Detect" section) of
the BIOS must be set accordingly. Refer to chapter 3 for more
information.
Important:
• If you are using the Wake-On-USB Keyboard/Mouse
• If you are using the Wake-On-USB Keyboard/Mouse
34
function for 2 USB ports, the 5VSB power source of your
power supply must support ≥ 1.5A.
function for 3 or more USB ports, the 5VSB power source
of your power supply must support ≥ 2A.
Advertisement
Table of Contents
