Table of Contents
Advertisement
3
BIOS Setup
PS2KB Wakeup from S3/S4/S5
The options in this field will allow you to use the PS/2 keyboard to
wake up the system from the S3, S4 or S5 state.
PS2MS Wakeup from S3/S4/S5
This field, when enabled, allows you to use a PS/2 mouse to wake
up the system from the S3, S4 or S5 state.
USB Resume from S3
This field, when enabled, allows you to use a USB device to wake up
the system.
Note:
To fully enable the USB wake up function, you must install the
VIA Suspend Wakeup Patch utility. The patch utility is included
in the provided CD. Refer to chapter 4 for more information.
VGA
When set to On, the system will respond and wake up to any VGA
activity.
LPT & COM
Select the port you would like the system to respond and wake up
when an event occurs on that port.
HDD & FDD
When set to On, the system will respond and wake up to any hard
drive or floppy drive activity.
PCI Master
When set to On, the system will respond and wake up to any PCI
or bus master activity.
78
Advertisement
Table of Contents
