Basic Wheel Alignment - Porsche 911 GT3 R 2012 Technical Manual

6.2.4. Driveshafts
6.3.

Basic wheel alignment

It is recommended that new cars and/or newly fitted driveshafts should be
run-in for approximately 100 km at a maximum speed of 200km/h at low
torque.
Only use Krytox grease to repack the joints when se

the driveshafts
Used driveshafts must not be exchanged fromt the left to

the right and vice versa
Tightening torque: 92 Nm (gearbox flange)

 Maximum running time: 30 hrs
Grease quantity outer joint:
Grease quantity inner joint:
Porsche part number:
In the event of an accident or any other damage occurring to the
suspension every component, including those not directly
affected, should be measured, checked for cracks and, where
necessary, replaced (e.g. steering, wishbones, uprights, ball-
joints, centre lock wheel nuts and all fasteners).
The wheel alignment should be carried out using an optical and/or
electronic or mechanical suspension alignment device. The measurement
procedure described in the device operating instructions should be
followed.
Electronic suspension alignment devices can be purchased from the
following company:
Beissbarth GmbH
Hanauer Straße 101
D-80993 München
Telephone: +49-(0)89-14901-0
Telefax: +49-(0)89-14901-285
www.beissbarth.com
rvicing
100 g
140 g
996.332.897.9A
74