Table of Contents
Advertisement
5.8.4. Release bearing
Input shaft
circlip
Ensure that the washer under the circlip (part of bearing inner
race) is seated correctly when fitting the input shaft. Ensure that
the marking on the gears on the input shaft (fixed gears) face to
the outside.
Under no circumstances whatsoever must gearbox come into contact
with the clutch release bearing seal otherwise the seal can swell which, in
the worst case, can result in the seal not functioning correctly.
Also, when handling the seal both hands and the working environment
must be clean and free of residual oil (this also applies to engine oil and
other oils).
According to the manufacturer the seal is only compatible with hydraulic
fluids of specification DOT4 and DOT5.
st
To change the 1
and 2
remove the differential
Remove reverse-gear shaft support
Remove oil pump drive gear
Remove 35x1.5 circlip from input shaft
(differential side)
nd
gear shaft
60
Advertisement
Table of Contents
