3.8.6. Removing and fitting the crankshaft seal – pulley-side
3.8.6.1. Special tools
3.8.6.2. Removal
Porsche Motorsport recommends use of the following special tools to
remove and fit the pulley-side crankshaft seal:
Retaining key pulley:
Adapter retaining key pulley:
Press tool crankshaft seal:
Spacer for press tool:
Protective cap crankshaft:
1. Remove the pulley from the crankshaft using the special tool
000.721.973.20 with the retaining key extension 000.721.873.20
2. Check the locating dowel on the pulley for damage and replace if
necessary
3. Centre-punch the steel ring in two points offset from one another by
180°
000.721.973.20
000.721.973.21
000.721.216.40
000.721.979.71
000.721.979.70
24