Porsche 911 GT3 R 2012 Technical Manual page 141

10.10.6.1. Checking the error memory
1 2
10.10.6.2. Clearing the error memo
In case a wheel speed sensor is disconnect and the ABS is activ
ABS error gets active. When the sensor is connected and works properly
the error message disappears wh
achieved.
To communicate with the ABS' ECU a special cable is necessary (see
parts catalog).
Zur Kommunikation mit dem ABS Steuergerät ist ein zusätzliches Kabel
notwendig (siehe Teilekatalog).
Connect ABS cable, turn on ignition, start XMIT

 When using XMIT for the first time one has to select the file
Xmite_Motorsport.dat in the field FS-map
 Click on read heart
 Click on „Conn-1 read"
Click on "EEPROM"  error memory is

3
 Possible errors are shown in the display on the right
 In case there are errors stored  fix them
ry
Mark „00_clear_error_s" (left display side)

 Click on „Conn-2 write"
 Rightclick on „00_clear_error_s"  execute
 Check the error memory one more time to ensure that the
previous detected errors are not present anymore
en a ground speed of 20 kmph is
being read
e. The
138