3Com 3CRWEASYA73 User Manual page 184

C 6: C L
HAPTER OMMAND INE
Table 19 802.1X Authentication
Command
802.1x
802.1x broadcast-key-
refresh-rate
802.1x session-key-
refresh-rate
802.1x session-timeout
802.1x-supplicant enable
802.1x-supplicant user
show authentication
802.1x
This command configures 802.1X as optionally supported or as required for
wireless clients. Use the no form to disable 802.1X support.
Syntax
Default Setting
Command Mode
Command Usage
I
NTERFACE
Function
Configures 802.1X as disabled, supported, or required IC-W-VAP 6-72
Sets the interval at which the primary broadcast keys
are refreshed for stations using 802.1X dynamic keying
Sets the interval at which unicast session keys are
refreshed for associated stations using dynamic keying
Sets the timeout after which a connected client must be
re-authenticated
Enables the access point to operate as a 802.1X
supplicant
Sets the supplicant user name and password for the
access point
Shows all 802.1X authentication settings, as well as the
address filter table
802.1x <supported | required>
no 802.1x
• supported - Authenticates clients that initiate the 802.1X authentication
process. Uses standard 802.11 authentication for all others.
• required - Requires 802.1X authentication for all clients.
Disabled
Global Configuration
• When 802.1X is disabled, the access point does not support 802.1X
authentication for any station. After successful 802.11 association, each
client is allowed to access the network.
• When 802.1X is supported, the access point supports 802.1X
authentication only for clients initiating the 802.1X authentication process
(i.e., the access point does NOT initiate 802.1X authentication). For
6-72
Mode Page
IC-W-VAP 6-74
IC-W-VAP 6-75
IC-W-VAP 6-75
GC 6-76
GC 6-76
Exec 6-76