3Com 3CRWEASYA73 User Manual page 180

C 6: C L
HAPTER OMMAND INE
Default Setting
Command Mode
Example
Outdoor 11a Building to Building (config)#radius-server retransmit 5
Outdoor 11a Building to Building (config)#
radius-server timeout
This command sets the interval between transmitting authentication requests to
the RADIUS server.
Syntax
Default Setting
Command Mode
Example
Outdoor 11a Building to Building (config)#radius-server timeout 10
Outdoor 11a Building to Building (config)#
radius-server port-accounting
This command sets the RADIUS Accounting server network port.
Syntax
I
NTERFACE
3
Global Configuration
radius-server [secondary] timeout number_of_seconds
• secondary - Secondary server.
• number_of_seconds - Number of seconds the access point waits for a
reply before resending a request. (Range: 1-60)
5
Global Configuration
radius-server [secondary] port-accounting <port_number>
• secondary - Secondary server. If secondary is not specified, then the
access point assumes you are configuring the primary RADIUS server.
• port_number - RADIUS Accounting server UDP port used for accounting
messages.
(Range: 0 or 1024-65535)
6-68