Changing Settings During Communication; Remote Control Setup [500] - Panasonic WJ-AV20 Operating Instructions Manual

CHANGING SETTINGS DURING COMMUNICATION

Remote Control Setup ............................................................... [500]
The following procedures are only available when the AV Codec is set to RECEIVER in the [100 MODE] menu, and the remote
site and control site are communicating.
The cameras connected to the remote sites, their video quality, and view points can be controlled from the control site during
communication.
0 0 0 T O P
↓
- - - M O D E ( R E C E I V E R )
- - - - - - - -
- - - - - - - -
- - - - - - - -
5 0 0 R E M O T E C O N T R O L / S E T U P
6 0 0 M A I N T E N A N C E
7 0 0 R E M O T E S E T U P
↑ ↓
: M O V E E N T : S E L E C T
5 0 0 T R A N S . C O N T R O L / S E T U P
5 1 0 C A M E R A . P R E S E T . T R I G G E R
5 2 0 V I D E O M O T I O N
5 3 0 V I E W P O I N T
↑ ↓
: M O V E E N T : S E L E C T
54
↓
↓
↓
E D I T
E S C : C L E A R
d
↓
O U T
↓
M O D E
↓
E S C : P R V
1 Move the cursor to item 500 in the TOP menu
by pressing the
the ENTER button.
• AV Codec in Control Site
The [500 TRANS. CONTROL / SETUP] menu appears
on the monitor screen for controlling the remote site.
• AV Codec in Remote Site
The [500 CONTROL] menu appears on the monitor
screen for controlling the local site.
This enables the selection of cameras and preset posi-
tions previously determined. The menu is the same as
[510 CAMERA . PRESET . TRIGGER OUT] menu.
Refer to the 510 menu for further operation.
Move the cursor to the desired item by
2
pressing the Direction buttons. Then press
the ENTER button.
• AV Codec in Control Site
The selected item submenu appears on the monitor
screen for controlling the remote site.
510: Enables the selection of cameras and preset
positions in the remote site.
This also enables setup of the specified camera
menu in the remote site.
520: Sets video quality transmitted to the control site.
530: Sets the view points in the remote site.
The setting methods are as same as [430 VIEW
POINT SETUP] menu. Refer to the 430 menu for
further detail settings
Receiver
or button. Then press