Before Starting Operation; Switching Power On/Off - Panasonic WJ-AV20 Operating Instructions Manual

BEFORE STARTING OPERATION

Switching Power ON/OFF

REMOTE
LINE
1
POWER
ON
OFF
c
Connect the remote
controller to the AV
Codec with the cable
supplied with the con-
troller. (Use the 6-con-
ductor DIN cable to
connect it to the front
of the AV Codec, or
the 6-conductor mod-
ular cable to connect
it to the rear.)
Remote Controller WV-CU20
ONE TOUCH DIAL
VIDEO ALM ACK
1 2 3 4 5
AUTO/MANU
STEP1 STEP2 STEP3
DIAL CALL
1 2 3
MEMORY REDIAL
4 5 6
7 8 9
DELETE
#
0
ALM MEMORY
ESC AUDIO MUTE
MENU ENTER
TELE WIDE AF NEAR FAR
Normally, keep the power switch
in the ON position during use.
When the power switch is pressed
off, calls cannot be originated or
received. Normally, keep the power
switch in the ON position and install
the supplied switch protector over
the power switch.
11
1
RING.VOL
LINE
2
2
3
Connect the Remote Controller to the AV Codec.
Connect the WV-CU20E remote controller to the controller jack or port on
the front or rear of the AV Codec.
Press the power switch on.
• When power is switched on, the power indicator lights up.
• The blue screen appears first after power is switched on. The present time
is shown on the monitor in about 10 seconds, and the AV Codec is in a
standby state and is ready for operation.
CLOCK
01/01/99 MON 00:00:00
PLEASE SET DATE.TIME IN CLOCK
SETUP MENU 410.
VIDEO1
TITLE
When you are not using the AV Codec for a long period of
time, press the power switch off and remove the power plug
from the AC outlet.
If the date and time are incorrect, then
correct them using the setup menu.
Standby screen appears in about 10
d
seconds.
01/01/99 00:00:00