Panasonic WJ-AV20 Operating Instructions Manual page 73

Connection of System Controller (WV-CU550A)
The system controller is connected to the data port on the
receiver side through a modular cable (furnished with the
system controller).
• Setting of AV Codec (receiver side)
Set the No.3 DIP switch on the receiver side to the OFF
position (straight). Make the following setting for the
[421 SERIAL DATA PORT]:
Rate: 9600 or 4800
Data: 8
Stop bit: 1
Parity: NON
Parameters of the serial data port should be adjusted,
without fail, between the transmitter and the receiver.
• Setting of the system controller
Setting should be performed with the following proce-
dures:
q Set the rotary switch at [0] on the rear of the system
controller.
w Set alone MODE switch 3 to the ON position, on the
rear of the system controller.
e Turn on the CONTROLLER switch while holding
down the AUX2 and STOP buttons on the system
controller.
The Baud rate setting menu is displayed on the
LCD of the system controller.
r Press the F1 (UP) or F2 (DOWN) button on the sys-
tem controller and select the same rate as the com-
munication rate set at [421 SERIAL DATA PORT] of
the AV Codec.
t Press the F4 (SET) button on the system controller.
The setting parameters are stored in the system
controller.
At this moment, the system controller setting has been
finished.
From the next time, the preset Baud rate is fixed even
after the CONTROLLER switch has been turned off.
(The auto-Baud-rate operation of the system controller
is not executed.)
Note: After the above setting is made, controlling the
cameras with the CAM-P mode are disabled. To select
a camera position, select a camera and then select a
preset position of the camera.
73
ON
1 2
3 2 1 1 1 SENSOR IN/TRIGGER OUT
IN PARALLEL PORT
RS–485
ON ↓ RS–232C
OFF ON
OUT
5 4 2 2
1 2 3 4 5 6 HOST PORT
IN VIDEO OUT LOCAL REMOTE AUDIO TEST REMOTE DATA PORT SETUP HOST PORT TERM
Set CONTROLLER
UNIT NO. at 0.
DATA CONTROLLER
IN OUT UNIT NO. MODE
1-8
TERM
0
ON OFF
BAUD RATE SETUP XXXX
UP DOWN
F1 F2
ALARM BUSY
F1 F2 F3 F4
ACK BACK FORWARD
1 2 3
RESET SEQ SEQ ALT PRESET
4 5 6
AF
7 8 9
AUX DEC INC ZOOM
1 2 -1CAM +1CAM STOP TELE
0
MON CAM
WIDE
ESC SET
Hold down these two buttons,
and turn on the CONTROLLER switch.
3 4 5 6
SIGUNAL GND
JW–AV20
AC IN
ISDN
AV Codec (receiver)
0
CONTROLLER
ON OFF
System Controller
(WV-CU550A)
SET
F3 F4
UP
IRIS
CLOSE OPEN
LEFT RIGHT
FOCUS
DOWN
NEAR
FAR
550 550
System Controller WV-CU A