Calling A Site By Dialing - Panasonic WJ-AV20 Operating Instructions Manual

CALLING A SITE BY DIALING

Note
Only one site can be connected. Two or more sites cannot be called at the same time.
There are various ways of calling a site by dialing as follows:
(1) Enter a telephone number to call a site.
(2) Call a site by one-touch dialing.
Press the DIAL button and then press a ONE TOUCH DIAL button to call the corresponding registered site.
One site can be registered for each ONE TOUCH DIAL button. It is convenient if the telephone numbers of frequently
called sites are registered in advance.
(3) Call a site by dialing a quick dial number.
A site can be called without entering the telephone number if it is registered in the directory in advance.
Up to 200 quick dial numbers can be registered in the directory.
(4) Sites can be called in turn by sequential dialing (with monitor points automatically switched from one to another). To make
sequential dialing effective, the sequential dial function must be set to ON when registering the quick dial numbers of sites
in the directory.
POWER
ON
OFF
Sensor
13
POWER
ON
OFF
AV Codec (transmitter)
for remote site
Point A
REMOTE
LINE LINE RING.VOL
1 2
AV Codec WJ–AV
Press DIAL button, and
then press a ONE TOUCH
DIAL button to call.
Quick dialing
q Press MEMORY button.
w Enter a quick dial number
(001 to 200).
e Press ENTER button.
r Press CALL button.
REMOTE
LINE LINE RING.VOL
1 2
AV Codec WJ–AV
AV Codec (transmitter)
Point B
for remote site
ISDN
AV Codec (receiver)
for control site
REMOTE LINE LINE RING.VOL
1 2
POWER
ON
OFF
Remote Controller WV-CU20
ONE TOUCH DIAL
VIDEO ALM ACK
1 2 3 4 5
AUTO/MANU
STEP1 STEP2 STEP3
DIAL CALL
1 2 3
MEMORY REDIAL
4 5 6
7 8 9
DELETE
0 #
ALM MEMORY
ESC AUDIO MUTE
MENU ENTER
TELE WIDE AF NEAR FAR
Remote controller
Point C
REMOTE LINE LINE RING.VOL
POWER 1 2
ON
OFF
AV Codec (transmitter)
for remote site
AV Codec WJ–AV
POWER
ON
OFF
Direct input of a telephone
number
q Press DIAL button.
w Enter a telephone number.
e Press CALL button.
To terminate communication,
press DIAL button for
2 seconds or more.
AV Codec WJ–AV