Panasonic WJ-AV20 Operating Instructions Manual page 80

Cause Value on Dialing Failure or Line Terminated
Code Monitor Display
#001 UNASSIGNED NUMBER
#002 NO ROUTE
#003 NO ROUTE
#006 CHANNEL UNACCEPTABLE
#007 CHANNEL UNACCEPTABLE
#016 NORMAL DISCONNECTION
#017 USER BUSY
#018 NO USER RESPONDING
#019 NO ANSWER FROM USER
#021 CALL REJECTED
#022 NUMBER CHANGED
#026 NON SELECTED USER
#027 REMOTE OUT OF ORDER
#028 INVALID NUMBER
#029 FACILITY REJECTED
#031 NORMAL DISCONNECTION
#034 NO CHANNEL AVAILABLE
#038 NETWORK OUT OF ORDER
#041 TEMPORARY FAILURE
#042 SWITCH CONGESTION
#199 (No display)
#255 (No display)
80
Dialing number is not currently assigned (allocated). Confirm dialing num-
ber. If it's correct, then ask your telecom service agent or the sales agent of
our service people.
No route to specifies the transit network.
Ask your telecom service agent or the sales agent of our service people.
No route to the destination.
Ask your telecom service agent or the sales agent of our service people.
The channel most recently identified is not acceptable to the sending entity
for use in this call.
Try to dial again. If impossible, ask your telecom service agent or the sales
agent of our service people.
Call delivered to an established channel.
Try to dial again. If impossible, ask your telecom service agent or the sales
agent of our service people.
Usually this information appears upon disconnection.
The called user is busy.
Try to dial again.
The user does not respond to receiving calls because the ISDN line cable is
not connected or power is off.
Confirm the connection between WJ-AV20 and the network and check the
power.
The user does not respond to receiving calls.
Confirm the MANUAL setting of [210 RECEIVING REGI.].Menu at the remote
WJ-AV20.
The remote user rejected the receiving call.
Confirm remote user.
Dialing number has already changed.
Confirm dialing number. If it's correct, ask your telecom service agent or the
sales agent of our service people.
The user has not been awarded the incoming call when the bus connection
is made.
To receive a call and communicate, register the local sub-address number
in [220 LOCAL NO.REGI.].
The user does not respond to receiving calls because the ISDN line cable is
not connected or power is off.
Confirm the connection between WJ-AV20 and the network and check the
power.
Dialing number is not valid. Confirm dialing number.
If it's correct, ask your telecom service agent or the sales agent of our ser-
vice people.
A facility requested by the user can not be provided by the network. Ask the
sales agent of our service people.
Usually this information appears on disconnection.
The called user is busy. Try to dial again.
The network is not functioning correctly and this condition is likely to last a
relatively long period of time. Ask your telecom service agent or the sales
agent of our service people.
The network is not functioning correctly and this condition is not likely to last
a long period of time. Ask your telecom service agent or the sales agent of
our service people.
The switching equipment is experiencing a period of high traffic. Try to dial
later.
Ask your telecom service agent or the sales agent of our service people.
ISDN line cable is not connected.
Confirm the connection between the WJ-AV20 and the network.
The configurations at the network or PBX have changed.
Please power off and on for WJ-AV20.