Language Screen; Diagnostic Ping Screen - ZyXEL Communications EMG2926-Q10A User Manual

Table 69 Maintenance > Sys OP Mode (continued)
LABEL
Access Point
Apply
Cancel

24.11 Language Screen

Use this screen to change the language for the Web Configurator.
Select the language you prefer and click Apply. The Web Configurator language changes after a
while without restarting the EMG2926-Q10A.
Figure 115 Maintenance > Language

24.12 Diagnostic Ping Screen

Use this screen to ping an IP address.
Chapter 24 Maintenance
DESCRIPTION
Select Access Point Mode if your device bridges traffic between clients on the same
network.
• In Access Point Mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled WAN.
There is no WAN port.
• The DHCP server on your device is disabled.
• The IP address of the device on the local network is set to 192.168.1.2.
Click Apply to save your settings.
Click Cancel to exit this screen without saving.
EMG2926-Q10A User's Guide
173