Ip Pool Setup; Lan Tcp/Ip; Ip Alias; Lan Ip Screen - ZyXEL Communications EMG2926-Q10A User Manual

Figure 48 LAN and WAN IP Addresses
The LAN parameters of the EMG2926-Q10A are preset in the factory with the following values:
• IP address of 192.168.1.1 with subnet mask of 255.255.255.0 (24 bits)
• DHCP server enabled with 32 client IP addresses starting from 192.168.1.33.
These parameters should work for the majority of installations. If your ISP gives you explicit DNS
server address(es), read the embedded Web Configurator help regarding what fields need to be
configured.

10.3.1 IP Pool Setup

The EMG2926-Q10A is pre-configured with a pool of 32 IP addresses starting from 192.168.1.33 to
192.168.1.64. This configuration leaves 31 IP addresses (excluding the EMG2926-Q10A itself) in
the lower range (192.168.1.2 to 192.168.1.32) for other server computers, for instance, servers for
mail, FTP, TFTP, web, etc., that you may have.

10.3.2 LAN TCP/IP

The EMG2926-Q10A has built-in DHCP server capability that assigns IP addresses and DNS servers
to systems that support DHCP client capability.

10.3.3 IP Alias

IP alias allows you to partition a physical network into different logical networks over the same
Ethernet interface. The EMG2926-Q10A supports three logical LAN interfaces via its single physical
Ethernet interface with the EMG2926-Q10A itself as the gateway for each LAN network.

10.4 LAN IP Screen

Use this screen to change the IP address for your EMG2926-Q10A. Click Network > LAN > IP.
Chapter 10 LAN
EMG2926-Q10A User's Guide
90