Wake On Lan Screen - ZyXEL Communications EMG2926-Q10A User Manual

The following table describes the labels in this screen.
Table 55 Configuration > Management > Remote MGMT > SNMP
LABEL
SNMP Settings
Server Port
Server Access
Secured Ip
SNMP Enable
Get Community
Set Community
System Location
System Contact
Trap Settings
Trap Enable
Trap Manager IP
Trap Community
Apply
Reset

20.7 Wake On LAN Screen

Wake On LAN (WoL) allows you to remotely turn on a device on the network, such as a computer,
storage device or media server. To use this feature the remote hardware (for example the network
adapter on a computer) must support Wake On LAN using the "Magic Packet" method.
You need to know the MAC address of the remote device. It may be on a label on the device.
Chapter 20 Remote Management
DESCRIPTION
The SNMP agent listens on port 161 by default. If you change the SNMP server port to a
different number on the EMG2926-Q10A, for example 8161, then you must notify
people who need to access the EMG2926-Q10A SNMP agent to use the same port.
Select the interface(s) through which a computer may access the EMG2926-Q10A using
this service.
Select All to allow all computers to access the EMG2926-Q10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG2926-Q10A.
Select this to enable SNMP on this device.
Enter the SNMP get community information here.
Enter the SNMP set community information here.
Enter the SNMP system location.
Enter the SNMP system contact.
Select this to enable trap settings on this device.
Type the IP address of the station to send your SNMP traps to.
Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
EMG2926-Q10A User's Guide
142