Table of Contents
Advertisement
4. Lamp & Lamp House
4.5
Installation of the lamp house
W
ARNING
C
AUTION
handled.
Necessary tools
7 mm flat screw driver.
How to install the lamp house of the projector ?
1. Ensure the projector is switched off.
2. Remove the lamp cover.
3. Hold fast the lamp house by its handles and gently slide the lamp house into its socket. Note that the compartment is provided
with guides (G) to position the lamp house correctly.
Image 4-20
4. Push the lamp house forward until it slides fully into the projector.
5. Secure the correct position of the lamp house by tightening all three spring lock screws as illustrated.
Image 4-21
6. Reinstall the lamp cover of the projector.
40
:
This procedure may only be performed by qualified technical service personnel.
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
C
G
R59770242 DP-1200 06/01/2009
Advertisement
Table of Contents
