Table of Contents
Advertisement
3. Physical Installation
3.3
Connecting the projector with the power net
W
ARNING
ble disconnect switch, circuit breakers and ground fault current interrupters. The installation shall be done
according to the local electrical installation codes.
C
AUTION
in a sealed compartment behind the rear cover of the projector.
C
AUTION
or AWG 10
Necessary tools
•
Flat screw driver.
•
Phillips screw driver PH2.
Necessary parts
•
Two cable ties.
•
Certified AC power supply cord 4.0 mm², 10AWG, min. 300V.
How to connect the main AC power with the DP-1200 projector?
1. Remove the rear cover and lamp cover of the projector.
2. Remove the cover of the main AC compartment by releasing the three captive dumb screws.
Image 3-6
3. Guide the AC power cord through the cable gland and connect the wires to the 3-terminal strip as illustrated.
Warning:
Always connect first the PE wire.
Image 3-7
22
:
The total electrical installation should be protected by an appropriate rated and readily accessi-
:
ALL POWER CONNECTIONS to the DP-1200 projector are made to the three-terminal strip located
:
The cross-sectional area of the conductors in the Power Supply Cord shall be not less than 4 mm
PE
R59770242 DP-1200 06/01/2009
2
Advertisement
Table of Contents
