Removal Of The Lamp Cover - Barco DP-1200 Installation Manual

10. Removal and installation of projector covers

10.1 Removal of the lamp cover

W
ARNING
Necessary tools
7 mm flat screw driver.
How to remove the lamp cover of the projector?
1. Release the two captive screws at the top and bottom right side of the lamp cover, using a flat screw driver.
Image 10-1
2. Remove the lamp cover from the projector doing the following:
a) gently pull out the left bottom corner (A) of the lamp cover,
b) then gently pull out the left top corner (B) of the lamp cover,
c) then move the lamp cover away from the projector (C).
B
A
Image 10-2
86
:
This procedure may only be performed by qualified technical service personnel.
C
R59770242 DP-1200 06/01/2009