Table of Contents
Advertisement
10.12 Installation of the front cover
The input cover and the lens may not be installed yet.
Necessary tools
7 mm flat screw driver.
How to install the front cover of the projector?
1. Check if the front filter is present.
2. Ensure that no lens is mounted and that the input cover is not installed.
3. Install the front cover of the projector doing the following:
a) first hook in the side of the front cover at the front filter,
b) then gently push the other side of the front cover into position,
c) ensure that the locking studs in the corners click into their receivers.
Image 10-23
4. Secure the front cover by locking the captive screw in the middle at the bottom of the front cover.
Image 10-24
5. Reinstall the rubber dust ring around the lens holder. See detail at the right of image 10-24.
R59770242 DP-1200 06/01/2009
A
10. Removal and installation of projector covers
B
C
97
Advertisement
Table of Contents
