Table of Contents
Advertisement
4. LAMP & LAMP HOUSE
About this chapter
This chapter enumerates all the supported xenon bulb lamps for the DP-1200 digital projector and how to replace the xenon bulb
lamp in the lamp house. Also included are the procedure to reset the lamp parameters, which is required after a xenon bulb lamp
replacement, and the procedure to realign the lamp in its reflector for optimal performance.
W
ARNING
XENON BULB LAMP HANDLING OR SERVICE.
C
AUTION
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accordance
to the manufacturer's instructions. The bulb is stable at room temperature, but may still explode if dropped
or otherwise mishandled. Whenever the lamp house, containing a xenon bulb lamp, has to be dismantled or
whenever the protective container or cloth has to be removed from the xenon bulb lamp, authorized protective
clothing MUST be worn!
W
ARNING
lamps.
W
ARNING
W
ARNING
Overview
•
Introduction
•
Removal of the lamp house
•
Removal of the xenon bulb lamp
•
Installation of the xenon bulb lamp
•
Installation of the lamp house
•
Resetting the lamp parameters
•
Realignment of the lamp in its reflector
R59770242 DP-1200 06/01/2009
:
DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
:
Xenon compact arc lamps are highly pressurized. When ignited, the normal operating temperature
:
Always wear face protection (full face shield with neck protector) when handling xenon bulb
:
Always wear protective clothing (welder's jacket) when handling xenon bulb lamps.
:
Always wear clean leather gloves with wrist protectors when handling xenon bulb lamps.
4. Lamp & Lamp House
27
Advertisement
Table of Contents
