Table of Contents
Advertisement
2. General
2.2
Unpacking the projector
What has to be done ?
At delivery the projector is packed in a carton box upon a wooden pallet and secured with banding and fastening clips. Furthermore,
to provide protection during transportation, the projector is surrounded with foam. Once the projector is arrived at the installation
site, it has to be removed from the carton box and wooden pallet in a safe manner without damaging the projector.
After unpacking let the projector acclimate to the room temperature which must be higher then 10°C (50°F)
and lower then 35°C (95°F). Neglecting this may result in a start up failure of the Light Processor Unit.
Necessary tools
•
8 mm Allen wrench.
•
13 mm open end wrench.
•
17 mm open end wrench.
How to unpack the projector ?
1. Remove the banding around the carton box, by releasing the fastening clips as illustrated, and open the box.
Image 2-1
2. Remove the smaller carton box (reference 1) as illustrated.
Note: The smaller carton box contains the manual.
1
Image 2-2
3. Remove the carton box and the foam around the projector. See image 2-2.
Note: The projector is still attached to a wooden plate, which is secured the below pallet.
4. Loosen the four nuts (reference 2 image 2-2) which secure the pallet as illustrated. Use a 13 mm open end wrench.
5. Rotate the wooden support plate with projector 90° and slide the front side over the edge of the pallet until the fixation screw
(reference 4) is visible as illustrated.
6. Remove the hexagon socket head cap screw (reference 4). Use an 8 mm Allen wrench.
12
2
3
R59770242 DP-1200 06/01/2009
Advertisement
Table of Contents
