Table of Contents
Advertisement
3. Physical Installation
3.1
Positioning the DP-1200 at port window
W
ARNING
General guide lines
•
Use a solid pedestal to put the DP-1200 projector on. Ensure that the pedestal can handle the weight of the projector and that
all feet of the projector are captured.
•
The pedestal should be placed in front of the port window wall in this manner that the projector front cover is at a distance of
minimum 20 centimeter from the port window.
Image 3-1
Barco offers a pedestal for the DP-1200 digital projector. This universal pedestal allows a solid and easy setup
of the projector. The universal pedestal has a separate compartment to install the UPS unit (if available) for
the DP-1200 digital projector. Futhermore, the universal pedestal contains a standard 19" rack to build in the
projector peripherals like alternative content switchers (e.g. ACS-2048).
Necessary tools
•
14 mm wrench.
•
17 mm wrench.
Projector centering
1. If the projector is standalone in front of the port window, center the projector with the theatre screen (see ref A image 3-2).
2. If a film projector is already present (projector will be off-center), try to optimize aim (see ref B image 3-2).
Note: Unlike film projectors, it is best to keep the projector lens surface as parallel to the screen as possible, even if it is
significantly above the screen center.
The off-center position slightly increase side keystone, but will minimize horizontal lens offset required.
18
:
The installation of the DP-1200 projector requires at least 2 persons.
20 cm
R59770242 DP-1200 06/01/2009
Advertisement
Table of Contents
