Connecting An Ups With The Projector Electronics - Barco DP-1200 Installation Manual

3. Physical Installation
3.5

Connecting an UPS with the projector electronics

W
ARNING
requirements", page 10, for more information about the requirements of the UPS.
How to connect an UPS unit with the projector electronics?
1. Install the UPS unit according the instructions of the manufacturer and the local regulations.
2. Connect the power output cord (reference 1) from the UPS unit with the UPS INLET socket of the projector (upper socket).
3. Secure the UPS INLET socket using the small fixation plate and two thumbscrews. Use appropriate spacers to ensure that the
plug is captured without play.
4. Install the large fixation plate (reference 2) upon the power OUTLET socket of the projector (lower socket). This to prevent loosing
the fixation parts.
1
Image 3-12
C
AUTION
AC power supply cord (minimum 0,75 mm² or 18 AWG and minimum 300V)
C
AUTION
26
:
Only use UPS units which are suitable for the DP-1200 digital projector. See chapter "Installation
:
The electrical connection with the UPS INLET socket of the projector must be done with a certified
:
Do not use the power OUTLET socket of the projector to provide power to other equipment!
2
R59770242 DP-1200 06/01/2009