Lamp & Lamp House; Introduction - Barco DP K-32B Series User And Installation Manual

4. LAMP & LAMP HOUSE
About this chapter
This chapter describes how to insert a lamp house in the projector and how to replace a lamp inside the lamp house and that for a
motorized lamp house as for a non motorized lamp house.
W
ARNING
XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XENON LAMP.
C
AUTION
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accordance
to the manufacturer's instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. Whenever the lamp house, containing a xenon lamp, has to be dismantled or whenever
the protective container or cloth has to be removed from the xenon lamp, authorized protective clothing MUST
be worn!
W
ARNING
W
ARNING
W
ARNING
Overview
•

Introduction

• Supported xenon lamps for the XL Lamp House
• Removal of the Lamp House
• Removal of the xenon lamp from manual XL Lamp House
• Installation of the xenon lamp in manual XL Lamp House
• Check if anode support must be provided with a plain washer
• Installation of the Lamp House
• Resetting the lamp parameters
• Realignment of the lamp in its reflector (manual Lamp House)
4.1 Introduction
Lamp and Lamp House
The DPxK-32B projector is delivered with a manual or motorized XL Lamp House without lamp. The xenon bulb lamp is delivered
separately and has to be installed on site by a qualified service technician.
The xenon bulb lamp is packed in a protective container or wrapped in a protective cloth. Never remove this protective container or
protective cloth without wearing adequate protective clothing (face shield, clean cotton gloves, welder's jacket).
R59770491 DPXK-32B 17/09/2012
:
DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
:
Xenon compact arc lamps are highly pressurized. When ignited, the normal operating temperature
:
Always wear face protection (full face shield with neck protector) when handling xenon lamps.
:
Always wear protective clothing (welder's jacket) when handling xenon lamps.
:
Always wear clean leather gloves with wrist protectors when handling xenon lamps.
4. Lamp & Lamp House
25