Lamp & Lamp House - Barco DP K-32B Series User And Installation Manual

Lamp & Lamp
House
About this chapter
This chapter describes how to insert a lamp house in the projector and how to replace a lamp inside the lamp
house.
WARNING: DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY
PHASE OF XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED
TECHNICAL SERVICE PERSONNEL ARE ALLOWED TO HANDLE THE XENON LAMP.
CAUTION: Xenon compact arc lamps are highly pressurized. When ignited, the normal operating
temperature of the bulb increases the pressure to a level at which the bulb may explode if not
handled in strict accordance to the manufacturer's instructions. The bulb is stable at room
temperature, but may still explode if dropped or otherwise mishandled. Whenever the lamp house,
containing a xenon lamp, has to be dismantled or whenever the protective container or cloth has to
be removed from the xenon lamp, authorized protective clothing MUST be worn!
WARNING: Always wear face protection (full face shield) when handling xenon lamps.
WARNING: Always wear protective clothing (welder's jacket) when handling xenon lamps.
WARNING: Always wear clean leather gloves with wrist protectors when handling xenon lamps.
Overview
•
Introduction
•
Supported xenon lamps for the XL Lamp House
•
Removal of the Lamp House
•
Removal of the xenon lamp from manual XL Lamp House
•
Installation of the xenon lamp in manual XL Lamp House
•
Check if anode support must be provided with a plain washer
•
Installation of the Lamp House
•
Resetting the lamp parameters
•
Realignment of the lamp in its reflector (manual Lamp House)
4
R5905754 /13 DPxK-32B 35