4. Installation procedures
4.8
Mounting the rental bracket on the FLX-HUB
Necessary tools
PH1 Phillips screwdriver.
Necessary parts
•
Four M3x10 cross recessed pan head screws, stainless steel (DIN7985).
•
Four single coil spring washers, D3.1 - D6.2 (DIN127B).
How to install the rental bracket on the FLX-HUB?
1. Place the rental bracket into position as illustrated and fasten with four screws. Use a PH1 Phillips screwdriver the fasten the
screws (reference 1). Make sure that each screw is provided with a spring washer (reference 2).
1
2
Image 4-13
2. Do you want to use a rigging clamp to install the FLX-HUB?
If yes, proceed with step 3.
3. Install the rigging clamp on the rental bracket as illustrated. Note the rigging clamp must has M10 thread.
Image 4-14
54
3
3
R59770419 FLX-60 12/05/2010