Table of Contents
Advertisement
4.7
Screw mounted FLX-60 pixel
Back access and front access is required to install the FLX-60 pixel with screws. The screws can only be
inserted at the front side.
The mounting hole for the FLX-60 pixel must require the specification of the cutting dimensions for screw
mount. See chapter "Mechanical requirements", page 10.
Necessary parts
3 screws M4x10 per pixel.
How to install the FLX-60 pixel with screws?
1. Place the FLX-60 pixel against the rear side of the mounting plate. Make sure that the mounting holes of the FLX-60 pixel matches
the holes of the mounting plate.
Note: The pixel orientation determines also the cable orientation. In and Out of the pixel socket should be in line to avoid
useless cable bends.
2. Fasten the FLX-60 pixel with three screws (reference 1) as illustrated.
1
Image 4-12
3. Connect the FLX-60 pixel with the connector string.
Reverse this procedure to remove the FLX-60 pixel.
R59770419 FLX-60 12/05/2010
4. Installation procedures
53
Advertisement
Table of Contents
