Table of Contents
Advertisement
Cables used with the FLX-NNI Controller
The FLX-NNI Controller unit comes with an EU power cord and a US power cord.
Image 3-12
Barco offers three lengths of NNI cables (HDMI plugs with latches) to connect the FLX-NNI Controller units with each other. The
different lengths are 1 meter, 5 meter and 10 meter. Note that one NNI cable of 1 meter is delivered with the FLX-NNI Controller.
Image 3-14
NNI cable of 1 meter with latch (R9854800: 5 pieces).
To connect the output ports of the FLX-NNI Controller with the FLX-HUB units Barco offers FLX-data cables with RJ45 plugs which
are equipped with IP66 protection shells. The FLX-data cables are not included because the length of these cables vary from
application to application. There are three lengths available: 20 meter, 50 meter and 100 meter.
Futhermore, Barco offers also an IP66 upgrade kit for the RJ45 plugs of a standard network cable. The standard network cables
used must be of the Cat 5 - STP type. Note that the maximum allowed distance between FLX-NNI Controller and FLX-HUB is 100
meter. Only the RJ45 plug at the side of the FLX-HUB requires IP66 protection shells.
Image 3-17
FLX-Data cable with IP66 protection shells for the RJ45
plugs (R9899436: 20 meter; R9899437: 50 meter;
R9899438: 100 meter).
R59770419 FLX-60 12/05/2010
Image 3-13
Image 3-15
NNI cable of 5 meter with latch (R9854790: 5 pieces).
Image 3-18
IP66 protection shells for the RJ45 plugs of the FLX-Data
cable (R9856140B10: 10 pieces).
3. Components of an FLX display system
Image 3-16
NNI cable of 10 meter with latch (R9854860: 5 pieces).
21
Advertisement
Table of Contents
