Error Codes - Canon M3010 Series Service Manual

Error Codes

Code Item
E000 Detection Startup failure
description
Remedy (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
(2) Replace the Fixing Assembly.
(3) Replace the Engine Controller PCB.
E001 Detection Abnormal high temperature
description
Remedy (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
(2) Replace the Fixing Assembly.
(3) Replace the Engine Controller PCB.
E003 Detection Abnormal low temperature
description
Remedy (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
(2) Replace the Fixing Assembly.
(3) Replace the Engine Controller PCB.
E004 Detection Fixing heater drive circuit error (200V models only)
description
Remedy (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
(2) Replace the Fixing Assembly.
(3) Replace the Engine Controller PCB.
E100 Detection Scanner area failure
description
Remedy (1) Check the connectors of the Laser Scanner Unit. (J1, J542 and J801)
(2) Replace the Laser Scanner Unit.
(3) Replace the Engine Controller PCB.
E196 Detection ROM read/write error (error in storing setting values in user mode/service mode/
description factory mode)
Remedy When the same error repeatedly occurs although the power is turned OFF and
then ON for several times, execute the following remedies.
(1) Update the firmware of the Main Controller PCB.
(2) Replace the Main Controller PCB.
E202 Detection CIS Unit home position detection error / homeward reading position error
description
Remedy When the same error repeatedly occurs although the power is turned OFF and
then ON for several times, execute the following remedies.
(1) Check the connection between the Main Controller PCB and the CIS Unit. (J2)
(2) Replace CIS Unit.
(3) Check the connection between the Main Controller PCB and the Reader
Motor (M3). (J11)
(4) Replace the Reader Motor (M3).
(5) Replace the Main Controller PCB.
7
Error Codes > Error Codes
Description
7 Error Codes > Error Codes
Code Item
E225 Detection Insufficient lamp light intensity (The light intensity is at the reference level or
description below.)
Remedy When the same error repeatedly occurs although the power is turned OFF and
then ON for several times, execute the following remedies.
(1) Check the connection between the Main Controller PCB and the CIS Unit. (J2)
(2) Replace CIS Unit.
(3) Replace the Main Controller PCB.
E301 Detection Insufficient light intensity at shading
description
Remedy When the same error repeatedly occurs although the power is turned OFF and
then ON for several times, execute the following remedies.
(1) Check the connection between the Main Controller PCB and the CIS Unit. (J2)
(2) Replace CIS Unit.
(3) Replace the Main Controller PCB.
E744 Detection System error
description
Remedy When the same error repeatedly occurs although the power is turned OFF and
then ON for several times, execute the following remedies.
(1) Replace the Main Controller PCB.
(2) Replace the Engine Controller PCB.
7-3
Description
T-7-2
7-3